...heater control valve. It is supposed to open and close to allow the hot coolant into the heater core when you switch the heat on. It will stick closed when it fails. It is located in the heater hose ...
heater control door (inside the heater box) is sticking in one position or the other. It's intended to direct air through either the AC's evaporator or the heater core, depending upon whether you want
heater control won't change from ac to heat heater control won't change from cool to heat. 2000 merc sable replace heater control switch in dash. good luck.
diagnostic for 2000 sable heater controls check fuse ...if problem remains check wiring on heater controls ... replace heater control unit
...WHEN ITS FULL OF FREON JUST TRYING TO SEE WHATS WRONG ITS WINTER there is a valve on one of the heater hoses that is run by vacuum if it don't work hot water will not enter the heater core. If it ...
...heater control valve situated under scullle panel common fault on ka set heater fan switch half way between hot and cold with heater blowing then touch valve if pulsing or clicking noise it is faulty ...
...hoses going to the heater core are getting hot when calling for heat in the car at the control knobs or levers. Is the fan working? Is air blowing sufficiently as controlled by the fan speed
heater control on warm. Then you try to feal if the hose som go to the heater are warm, if only one are warm the fault are the tap. And then you must look under the dashboard and lokate the tap. Hoope
...control system your controm box may be burnt out this will need replacing heater valve to let the coolant into the heater core is not working the heater cluster in your dash that controls the heat ...
heater control valve. A lot of times they will rust up and stick closed, especially after a summer with it being off. It is pretty easy to fix and inexpensive. There is also a vaccume line to it. Make
2,993 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,431 Questions
1,365 Questions