...ignition switch electrical connector. Rotate the ignition switch to the RUN position. Remove the two screws retaining ignition switch. Disengage ignition switch from the actuator. When installing new ...
ignition switch my ignition switch turns freely. the car will crank but will not shut off. i replaced the ignition switch but it is doing the same thing. what is the problem? The lock cylinder where ...
...ignition switch problem. Car would not go off when switch ignition to off position. Turned off by removing fuel pump fuse. Replaced ignition switch. Car won't start. Control panel and radio now ...
...ignition switch half way between the run and start position, replaced the ignition cylinder, still have the same problem. The cylinder is "clocked" to fit with 180 degrees respective to the Ignition ...
...ignition switch? I charged it at a autostore and 1 week later.. when I tried to start it ..the ignition stuck and made a very loud noise then the car wouldn't start. thanks IF SWITCH GETTING STUCK ...
ignition switch box, under the dash on the column. It pushes the ignition switch to start and pulls it back to stop and lock. If you remove the 2 hex screws on the yellowish ignition switch and let it
Question about Ford Thunderbird
...ignition switch on the lower part of the column and I am assuming that your changing the ignition switch on the lower column you have to put the rod up into the ignition cylinder first then attach it ...
...faulty ignition switch, starting solinoid, starter motor or ignition interlock device tied into the factory security system. try original key. Original key will communicate with security
...the + side of the coil? The ignition switch wire or the distributer wire? Ignition Switch Wire I thought dist wire, but my 55 has ign wire on pos side,tried to switch,didn,t start good ,switched ...
750 questions posted
Usually answered in minutes!
523 Questions
431 Questions
394 Questions
202 Questions
226 Questions