...axle nut,swing spindle out to get the axle out of the sealed bearing,then pop the axle out of the center section with a prybar(held in with an internal clip that just puts light pressure on the
Question about Ford Explorer
axle with u joints that go through a bearing hub on the rotertif thats the case the spindle has 6 nuts take them off you can get the special tool a sliding hammer to take it off i just use a dead blow
...spindle. Set the indicator to zero. Firmly grasp the brake disc and move it in and out. The total movement shown on the indicator is the amount of freeplay at the bearing. Compare your reading to the ...
axle you will need to remove. then there is 4 bolts on the back of the steering knuckle by the cv boot that will need to be removed. then you just have to pull the hub and bearing assembly out by hand
...axle shaft. Use appropriate spindle nut socket to remove spindle nut ratchet assy. Remove Hub. Position hub on floor and pry seal from hub. Hammer in new seal. Reinstall hub and bearings. Torque ...
...seal? Raise and support vehicle, remove left front wheel, separate left front spindle and remove axle nut, remove left front axle, now you can get to axle seal. Replace seal and reinstall front
...axle. Refer to Wheel Spindle, F-150, F-250, F-350 in the Removal and Installation portion of this section. NOTE: Lower ball joint must be removed first. Install the front wheel spindle in a vise and ...
Question about Cars & Trucks
...axle nut, Pull spindle away from strut, push axle out of hub, use pry bar and pop axle from Tranny. Make sure when you reinstall axle into tranny your careful not to rip tranny axle seal.Make sure it ...
...spindle. I suspect the seal surface got damaged, requiring a repair kit. There is no markings on the seal. The OD of the old seal is stock diameter. But the ID of the seal is about 200 thousandths ...
...toward the wheel ? how do proceed THE AXLE HAS TO COME OUT OF SPINDLE USE A PRY BAR BEHIND THE AXLE AND PRY IT OUT OF THE SPINDLE IF THIS IS A VACCUM OPERATED SPINDLE THE SEAL WILL (HAS TO ) COME ...
859 questions posted
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions