2006 Ford Explorer "fuel pump relay" Questions

...fuel pump relay. Now I think it's either the power distrubition box or the fuel pump. I don't hear any noise when you turn on the key from the fuel pump. No noise from fuel pump when you turn ...

...fuel pump,new fuel pump relay,no power to fuel pump after putting a new fuel pump an fuel pump relay,i get no power to the fuel pump. Have you checked the fuel ppm cut off switch? It should be under ...

...FUEL PUMP AND FUEL PUMP RELAY Hi there. The fuel pump relay is in the power distribution box in the engine compartment under the hood. Find the box with the fuses and relays in it then go to the # 5 ...

fuel pump not working, will not prime, cranks but no start unless putting fuel in intake Ran 12 volts strait to pump worked fine Check voltage and ground at fuel pump, pink wire is voltage black wire ...

fuel pump runs when key is off If your pump is continuing to run with no regard to the key position your fuel pump relay has failed in the on position. This happens when the secondary contacts fuse ...

...fuel pump when I turn the key on. I have checked the fuel pump emergency shut off located in the rear inside quarter panel. The owners manual indicates relay 303 for the fuel pump. This relay is not ...

...fuel pump will not turn on. Rocking the ignition switch will sometimes get the fuel pump to engage. Jumping the vehicle has gotten the fuel pump to turn on. I have checked, swapped and replaced the ...

...fuel pump relay in a 91 ford explore?? In the underhood power distribution box, the fuel pump relay is the same as the a/c relay swap the two and see if your pump starts to run, if so replace it, if ...

...fuel pump Try looking at the fuse under the hood make sure your getting 12 volts at fuse.If fuse is good but no power try checking the fuel pump relay. you can switch the relay with another system ...

...to fuel pump. 1993 Ford Explorer 4.0L check fuel pump ground wire for clean wire to frame contact also check fuse and relay, jump power across relay to force voltage to the pump with pump relay