2005 Dodge Ram 1500 "pcm replacement" Questions

...What can I do? should I get it diagnosed before I buy a ECM? A code P0601 in most cases means the PCM has gone bad. This is possibly due to a short-circuit inside the PCM. Or, if you disconnect the ...

...Sum Error Basically that means that there is an interal fault in the Powertrain Control Module (PCM). There have been many reported PCM failures on Chrysler/Dodge products although it is possible ...

If I replaced the PCM on the 2005 dodge ram truck would I have to reprogram the keys to make the truck run? If you key has a chip in it, you will probably have to get your ECM reprogrammed with the ...

where is the pcm on my dodge ram 1500 5.7 hemi 2005 where can i get the pcm rebult or reprogramed PCM LOCATED IN THE RIGHT REAR CORNER OF THE ENGINE COMPARTMENT ON THE FIREWALL. DEALERSHIP HAS TO ...

...keeps running. The error code is p0601. Please help me with this question . Thanks. posible a bad pcm There is an internal error in the Powertrain Control Module (PCM) system. Read more: ...

...you help? DTC P2106 Throttle actuator control system-forced limited power DETECTION CONDITION ? The PCM monitors the throttle actuator control current when the ignition switch is on. If the control ...

...mechanic. Paid $85 for a diagnostic test. Truck died while testing. Report was given out as a bad PCM. They wanted to charge me $500 for the part and another $300 for labor. So I had it towed home. ...

...Problem 1 of 6: The 5v power supply from the Powertrain Control Module (PCM) is shorted due to a shorted Crankshaft Position (CKP) Sensor. Test & Fix: If the 5v ...

...MAP connector, voltage should be less than 0.2 volts. If not inspect for open harness from pin 4 of PCM harness and terminal A . If no voltage is present, proceed to the next step. Turn the ignition ...

...replacement ecm? just one code, and not tranny shifting issues>????????????????????? why blame the PCM first, its dead last, then say that again. why blame the most expensive part one car ...