1984 Chevrolet S-10 "blazer engine amp" Questions

...blazer, misfire #6, have changed wires,plugs, dist cap & rotor button, had the code checked & cleared after each change but always get Misfire #6 after hitting 45 mph.No misfire at low speeds ...

...blazer 4.3L CPI (VORTEX) 4x4. I have changed the MAP sensor Coil Spark plugs Spark plug wires fuel filter and battery. The fuel pump works fine and it rolls over. When it does start it will stall ...

...blazer has developed a heater core leak. Where can I get the procedure for R & R of the core? Please don't forget to rate! Thanks! Removal & Installation The heater core is removable from ...

...Blazer just replaced fuel pump now it is idles at 1500 RPM's what should I do. Try cleaning the Idle control valve (IAC), If your lazy like i am use the whole throttle body cleaner and spray it ...

...Blazer V-6, pump and houses. Power Steering Pump Removal & Installation 2.2L Engine To Remove: Remove the upper cooling fan shroud. Position a fluid catch pan under the power steering pump. ...

I was driving my 99 Chevy Blazer & it just shut of & I lifted the hood smoke was going out what could be wrong If you overheated the engine the engine will shut down

Blazer Engine Swap Part 1 of 2 - YouTube ? 10:29 https://www.youtube.com/watch?v=Dt_7AKP2WcI Aug 13, 2011 - Uploaded by Dave R Replacing the engine in a mid-size Chevy Blazer 4x4 with oneout of a Jeep

...in the engine compartment but the radio shouldnt be under the hood i know i have a blazer 2001 blazer 4x4 codes PO-740 & PO-785 & P-1860 showing where are they located & what are

...Blazer with 4.3 V6 engine are attached to right connecting points on distributor cap. The firing order for a Chevy s10 depends on which engine you have. 1.9L engine the firing order is: 1-3-4-2 . ...

...blazer temperature warm up? You may have vapour lock in your heater lines. Start engine, put heat lever on high, disconnect one of the lines on your heater core, the one on the flow out side, & ...