1999 Chevrolet Astro "1988 30 engine cover" Questions

30 ft. lbs. Oil Pan1979Step1Large Bolts11-13 ft. lbs. Small Bolts7-9 ft. lbs. Step 2Large Bolts15-17 ft. lbs. Small Bolts10-12 ft. lbs. 1980-879-11 ft. lbs. 1988 and up6-9 ft. lbs. Oil Pick-up Tube-to

...1988 Audi 5000 CS TQ with 173000 miles. Last month the car started to have 2 misses at cold start (cant remember for hot starts) that you could actually HEAR go away after the first 30 seconds of ...

30 Nm) on 1988-90 models. Make sure the pump impeller is able to turn freely. Install the water pump inlet tube and the inlet tube gasket and fasteners. Install the rear timing cover stud. Install the

...30 ft/lbs Oil pan mounting bolts -1979 --Step 1 (Large bolts)11-13 ft/lbs --Step 1 (Short bolts)7-9 ft/lbs --Step 2 (Large Bolts)15-17 ft/lbs --Step 2 (Short Bolts)10-12 ft/lbs -1980 to 19879-11 ...

...1988 Chevy Tahoe. However, it may be similar to a Suburban R10: REMOVAL & INSTALLATION The following is a general procedure for all trucks covered in this manual, and may vary slightly depending ...

...1988-89 DOHC Preludes, use sequence B. Use sequence C on 1992-95 Preludes with 2.3L and VTEC engines. On 1984-89 Accords and 1984-91 Preludes, tighten the bolts in two passes. The first pass should ...

...engine. Tighten the bolts to 35 ft. lbs. (47 Nm). Install the idler arm on the center link. Tighten the nut to 30 ft. lbs. (41 Nm). Install a new cotter pin. Install the crossmember. Remove the floor ...

...1988-89 DOHC Preludes, use sequence B. Use sequence C on 1992-95 Preludes with 2.3L and VTEC engines.On 1984-89 Accords and 1984-91 Preludes, tighten the bolts in two passes. The first pass should ...

...1988 model and that starts almost before you turn the key! Never ever failed. Not even in minus 30 degr. Celsius. This has been done. Computer changed-no diference, the 3 coil spark-ignation modul ...

...30 inch lbs. Place the fuel tank on the jack and elevate it into place within the car. Attach the straps and install the strap bolts, tightening them to 29 ft. lbs. Connect the breather hose to the ...