...3 fluid level in the master cylinder o.k. ans there are no leaks from either the hose or slave cylinder. Replace both clutch slave and master cylinders, and bleed well. I've also had this happen. ...
...bleed-one to pump it up,hold it down then another underneath to open the bleeder-only open for a short time,then close and pump up again-should only take like 3 times-don't let the peddle up while ...
...3 Brake Fluid. Actuate clutch pedal briskly at least 50 times. Verify release system function. Repeat. If release system is still inoperative, continue with procedure. Raise and safely support the ...
Question about Mazda B2200
...bleed the slave cylinder with dot 4 (dot 3 is recomended for my car) the clutch is not working at all (has no resistance).what do you think is the problem? i m sure i did the bleed properly, but i ...
Question about Nissan Cars & Trucks
...screw on the slave cylinder and let fluid drain for about 30 seconds hi, have somebody to pump 3 times on the pedal, then bleed on the slave, repeat 3 times or until there is no air comming
...bleed the clutch. Have somebody pump the pedal fast about 3 or 4 times, on the last pump hold pedal down and close bleeder. Make sure fluid stays full in master cylinder, try it again, if it still ...
...pedal ,pump a few times then hold down ,you push the clutch arm in with a bar and open the bleed nipple at the same time then close the nipple and repeat ,after about 3/4 goes it should have ...
...3 oil. HYDRAULIC CLUTCH BLEEDING 1. Clean cap. Remove reservoir cap and diaphragm. Fill reservoir and keep full throughout procedure. Attach hose to bleed screw on actuator and submerge other end in ...
...3 time hold it there to the floor open bleeder oil come out close bleeder repeat a few time don t forget to check mthe oil level add if needed thanks pierre p.s you may need to lift the clutch pedal ...
Question about GMC Cars & Trucks
...bleed the hydraulics after the repair? 2 Did you check the master cylinder rubbers? Best to overhaul it while you are doing the work in any case 3 Did you check the slave cylinder rubbers? Look for ...
546 questions posted
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions