knock sensor goes in a Chevrolet avalanche 2003 knock sensors there are two are underneath intake manifold. make sure whoever replaces them they must use RTV SEALANT ON BOOT COVERS SO THEY
knock sensor on the engine need picture or engine diagram Hi!! The Knock Sensor is located on the right side of the engine block, right below the exhaust manifold. See #7 on picture below: Good Luck!!
...pressure when cold? it could possibly be a knock sensor bad. if you have a bad piston or rod it would knock all the time not just cold,i would look at other things like the belt tenionser and ...
...sensor. Hello: Approximately 2 - 4 hours depending on the ability and experience of the technician performing the task. There are two sensors, both should be replaced. The intake manifold has to be ...
...knock sensor is under the intake manifold. The good news is this is a fairly easy fix as far as removing the intake goes. I assume you have the 5.3 engine? In the many cases where i have replaced the ...
how do you change knock sensor Here's a link to your knock sensor and how to replace.
chevy avalanche knock sensor (2002) where is the knock sensor located? the knock sensors are under the intake on the valley cover
...knock sensor.My question is will the cknock sensor cause the engine to make this noise? Does it only do it when cold? If so, this is "normal." Its b/c metal contracts when cold, and the tolerance of ...
...have to remove the intake manifold to gain access to the oil pressure sensor. If the engine is not knocking or there isn't any valve train noise then it could be the oil pressure sensor when this ...
KNOCK SENSOR CIRCUIT LOW INPUT BANK 2 CONDITIONS, POSSIBLE CAUSE KNOCK SENSOR FAILED, CODE P1875 4WD LOW SWITCH CIRCUIT MALFUNCTION CONDITIONS FOR TRANSMISSIONS 4L60E 4L80E, POSSIBLE CAUSES 4WD SWITCH
738 questions posted
Usually answered in minutes!
538 Questions
471 Questions
356 Questions
231 Questions
97 Questions