2002 Ford Explorer "transfer case" Questions

...TRANSFER CASE ON A 2002 FORD EXPLORER 6CYLS remove the front and rear drive shafts and remove the bolts from the transfer case around the transmission the transfer case will then slide backwards and ...

transfer case will not engage. Trans output shaft is turning because it will grind if I try to put it back in park. must shut down engine then place trans in park. No bangs, grinds vibrations ect when

transfer case, (little knob to change to 4x4), then the motor may have gone out. There are several fuses and relays associated with the 4x4. Check all of the fuses, replace any that are burnt out. You

...transfer case motor wiil not shift out of 4 wd hi. the wire harness from this transfer case motor goes to three seperate locations. Four wires go to a connector at the rear of the transfer case just ...

...transfer case has a motor mounted on the exterior of the transfer case,and they do go bad.There is also a transfer case controller (computer) that is part of the Body Control Module (BCM) and i have ...

...transfer case noise on deceleration only but doesnt affect performance, almost sounds like when a car is still rolling & you put gear selector in park what could it be? vehicle is a 97 ford ...

transfer case and detect the speed of the front and rear driveshafts. This input is used by the generic electronic module (GEM) primarily to control A4WD operation. The throttle position output signal

transfer case on my 1998 ford explorer will not come out of 4 low. The switch is not allowing it to change to 4 high or automatic. I was wondering if there is any way to find a scematic diagram of the

transfer case fluid? How do I know if Im low on fluid in my transfer case? Under the truck at the rear of the transfer case there is a plug, pull it out, you should be able to touch the fluid with ...

Transfer case motor circuit has short draining battery Removed neg. battery lead and checked DC amps between lead and battery. Was able to determine that transfer case motor circuit is intermittenly ...