2006 Dodge Stratus "torque converter bolts" Questions

...torque converter to the drive plate ,unbolt then 4 bolts and the torque converter comes away with gearbox ,also refit this way because you can damage the seal between primary input shaft and the ...

...checked engine OK, sounds like loose bolt inside, someone said it sounds like an exhaust problem. It could also be a number of things...but you could check the torque converter for a loose bolt

...torque converter is bolted to the flex plate but not 'till the transmission with the converter installed and retained temporarily has been bolted in place. A clutch is bolted to the flywheel but not ...

2006 dodge stratus,4 cylinder has loose torque converter bolts. How do i access them to tighten them up ? take starter off

...torque converter housing cover. Remove the lower bolt attaching the A/C compressor to the oil pan. WARNING!!!!! Be sure to remove the 2 bolts attaching the timing cover to the oil pan, as damage to ...

...Torque converter housing cover>  The lower bolt attaching the A/C compressor to the oil pan>  Oil pan fasteners, Oil pan and gasketPlease note that attempting to remove the exhaust ...

...torque converter bolts or nuts 7remove all the bolts attaching the trany to the engine make sure you have a floor jack to receive the trany when it fail down do not work under the car or check it to ...

torque converter attaching bolts. Tighten bolts to following torque: 40 ft. lbs. (54 Nm) with 9.5 in. 3-lug converter 55 ft. lbs. (74 Nm) with 9.5 in. 4-lug converter 55 ft. lbs. (74 Nm) with 10.0 in.

...torque converter bolts Please don't forget to rate! Thanks! Transaxle mount and torque the bolts to 65-80 ft. lbs. (90-110 Nm) Torque converter and torque the bolts to 34-39 ft. lbs. (46-53 Nm) ...

...torque converter is seated all the way.so my question is does the spacer on the flywheel go on before or after flywheel and which way does the flywheel face last time bolts for both flywheel and ...