2000 Mazda MPV "rpm" Questions

my mazda 2005 overheat but if i put high rpm like 3000 the temp. go to normal i allready change the termostat and water pump Sounds like you need a new water pump. When you turn the engine at high rpm

rpm is high above 1.5 when started speedy exhaust becomes red , rpm is when started speedy exhaust becomes red , ihave cleaned the catalytic converter.check light is on (germatory is high) iam in ...

jerking at low milleage runs smoothly below 1.5 rpm. After, it roughen when not driving and jerks if on motion. At rpm above 2 it moves as if there is no problem Your torq converter is failing, I ...

engine rpm,s too high on a 2004 mpv mazda the engine is idling at 2500 rpm,s and the temp guage and cooling fan won,t work either. I checked the fuses and checked for a vacuum leak also. cheak for the

...2005 MPV shuts off after I let go of the gas ;pedal after high acceleration. Checked idle and high rpm voltage which tested ok. Spark plugs ok. No obvious signs of a vacume leak. problem occurs in ...

If I accelerate my Mazda MPV 2005 after 3, 000 RPM, the engine shuts off, or if a suddenly accelerate to change lane and it passes , 3,000 RPM the same happens. I dont think is a mechanical problem ...

...automatic transmission at 2-3 gear When I start the van from stop, 1-2 gear is smoth. If I keep the rpm below 2500 at slow acceleration, 2 to 3 gear is smooth too. If I accelerate a little harder to ...

...MAZDA MPV eith a 3.0L 24 valve DOHC that will not idle down. It is at a constant idle of 3500-4000 rpm and when given gas sticks at a higher rpm even when you let off the gas pedal. I had shut the ...

...as if it is missing when I drive. When I am stopped and it does this I notice a slight drop in RPM's. In addition the engine cooling fan is not running at a constant speed, I notice this most ...

air in the radiator HOW TO RELESE PRESURE OR AIR OUT OF THE RADIATOR SYSTEM Remove the rad cap, start engine, rev at 2,000 rpm for 1 minute, replace rad cap while engine still running