...Oil Pressure Sending Unit on a Jeep Wrangler 2000 6cyl so i can replace? Oil Pressure SensorThe 3 wire, solid-state engine oil pressure sensor (sending unit) is located in an engine oil pressure ...
Question about Chevrolet Impala
...oil pressure. changed sending unit, oil pump and checked with mechanical gauge, what's next? 2002 jeep wrangler x 4.0 no oil pressure. changed sending unit, oil pump and checked with mechanical ...
...oil pressure sending sensor to leak oil from the connecter? With jeep oil pressure sending units, it is common. They tend to leak, with oil coming out of the wire connector. You will have to replace ...
...oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter Removal & InstallationDisconnect the negative cable from the battery. Raise vehicle on hoist. Remove front splash shield. ...
oil pressure loss I have a 2000 jeep cherokee laredo with an in line 6. The oil pressure gauge shows sudden oil pressure loss, but the the gauge recovers. Is the oil pump going out? the 1st thing u do
...oil pressure gauge to fluctuate on my 2004 Jeep Grand Cherokee Laredo? If the oil pressure is good and there is no engine noises then the oil pressure sending unit is the problem.Just replace it and ...
Question about Chevrolet Impala
oil pressure reads High all the time My jeep runs great but the oil pressure gauge reads high all the time, none of the sensors online match my vehicle. oil pressure sending unit is not working right.
Question about Chevrolet Impala
...oil pressure Starts up Fine when cold but hard to start after its warm, Oil pressure fluctuates from around 10 at Idle to around 40 when moving. Hi there:It sounds like it could be oil pressure ...
Question about Chevrolet Impala
oil pressure sending unit on a 1993 jeep grand where is the oil pressure sending unit on a 1993 jeep grand cherokee on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor,
oil pressure gauge not reading on my 1994 jeep wrangler. oil is full just the guage has no pressure and not alot of power The oil pressure specification for your engine is 13 PSI at idle hot, 37 to 75
932 questions posted
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,386 Questions
1,400 Questions
1,452 Questions