2007 Jeep Wrangler Unlimited Rubicon 2 Doors "idle installing new throttle" Questions

...NEW CARB ON AN 88 JEEP HOW DO I ADJUST Adjustment screw is usually capped and non accessible unless you drill it out. If you are lucky and get one without a cap attach a vacuum gauge and tach to the ...

...new defective part to the mix. yes finish the tune up, why did you do it last>? odd no? vacuum leaks cause, high idle on all jeeps!! and then the ECU sees bad idle and tries over and over to reach ...

...new checks out at pulling 100 amps. I have added a 950 cca battery. I replaced the alternator which is 160 amps. Should not be any problems. When checking the amps coming from the altenator it only ...

idle high after installing a new throttle body for 2003 nissan altima idle high after installing new throttle body for 2003 nissan altima turn the idle stop screw down

installing the sensor? this is on a 1998 mazda 626 4 cyl. I installed the new tps and the problem still occuring. The engine cuts out when at 2000-3000 rpms. the computer at autozone said tps bad, cyl

...Idle Air Control (IAC) valve which is mounted to the throttle body - cutaway view shows air bypass direction --- REMOVAL & INSTALLATION Disconnect the negative battery cable. To remove the IAC ...

idle at 1500 to 2000 rpm 2001 2.4l cavalier idles high. Throttle body and IAC motor cleaned. No change, New IAC motor installed, Still idles at 1500RPM. Smoke test shows no vacuum leaks. HELP Most ...

...new spark plugs, pcv, idle air valve, have sprayed all wire plug connector 98' rodeo idles high rpm's of 1500 and down to 1000 sometimes i have replaced the egr, throttle position ...

...installing a new idle control sensor. No screw - fully computer controlled. Also, there is no idle control sensor - just a throttle position sensor (TPS) and an idle air control (IAC) motor. If you ...

...new battery and water pump on my 1986 Isuzu Trooper and it runs at 3000 RPM with no throttle applied. It seems like a problem with the throttle shaft being misaligned or stuck. Can anyone help with ...