2008 Kia Rio "car firing changing water pump" Questions

...water.(Jump on bumper to mix thoroughly) then pull the fuel pump relay and crank engine over about 9 or 10 revolutions with the gas pedal to the floor. This increases air flow and dries out the ...

...changing water pump remove water pump from falcon replace with new pump add antifreeze top up with water and now turn over but wont fire into life ? Have you disconnected any other wires at the fuse ...

water pump change and now wont start i recently changed my water pump and noticed that when i try to start it, it struggles and appears to me to be dieseling after i let off on the key. it acts if ...

...pump cause this? no...water pumps do not cause backfires. faulty water pumps causes overheating. backfiring is caused by incorrect firing order. the connection of your high tension wires are ...

Firing order for Microbus 2.1 My water pump died and needed to be changed, mi removed the pump, however, before removing the water pump, I removed the distributor completely then followed the pump. I ...

water pump,and replaced a freeze plug in back of engine and still not getting heat? it possible your heater core may be clogged. the heater core is mounted on the fire wall inside the vehicle. you can

runs real rough and back firing no compression after all belts and water pump changed firing order diagram 1986 check the timing..

...if it had power before because I bought it n never got to crank it because it needed the water pump. Do u no y it don’t have any power? 1342 is the firing order here is the pic for u I hope this ...

...or what??? the firing order is 1-3-4-2,,,,,next time you change the plugs only change one plug at a time,,,that or mark your leads with 1-2-3-4 the No 1 plug is the front cylinder by the water

...Car has been sitting a year and now will not start. Its getting gas and fire. It acts as if it wont's to start but will not. I have changed the plugs, and i have check the coil. What can i do? Change ...