Whirlpool LTE5243D Top Load Stacked Washer/Dryer "water level sensor" Questions

...water level sensor Change the water level sensor (sensor pressure) is low. (sensor pressure). The drain motor does not work -  Test and if faulty change the drain pumpMessage = E9 Error = SENSOR ...

...water level sensor is defect, or a cable got lose. or the tube connected to the sensor is leaking air. Lots of causes. But please first close the water tap. Then try t drain the water. Perhaps like ...

water level sensor or what would cause the water level to keep going up and spill over there is a water level sensor that you set by the water level required for the wash when that level is reached it

water level sensor, included to check the small hose from the drum to the water level sensor. there must be pressure from the water to suppress these sensors, the operation of the washing machine are:

...water level! Washer only has low water level in all wash settings. If the water levels are low in your washing machine then you could have a sensor that is faulty . The fill sensor will communicate ...

...Water level sensor fault This fault code is fairly self-explanatory and tells you that the washing machine has detected an error with the pressure sensor or pressure switch Check water level ...

...Water Level Pressure Sensor Error. 1) Verify that the black tube is still connected to the Water Level Sensor at the top of the washer---and to the Air Bell at the bottom of the tub. 2) Remove the ...

...water level faulty pressure sensor cause it? Humming sound can be heard. Manual draining is ok Yes, a faulty water level pressure sensor can cause a washing machine to get stuck at the rinsing cycle ...

...water There is either something clogging the air tube to the water level sensor or the water level sensor itself is bad. If you need help accessing the air tube or water level sensor feel free to