...cube sticks carefully. My bet is that the blades are ever-so-slightly bent toward one another - or the factory remove-before-use lable remmnants are still on one of the facing blades. If label is ...
...Still dispensing crushed even when on cubed ice type If this is a mechanical unit, look for a bent or broken part. Electrical...this will likely also be a bent or broken part. Unplug before ...
suggestions? Thank you for your time and expertise. If there are blades involved then they might be bent and/or need sharpening
...use a bar or a sensor to shut off water when ice levels are at a maximum. Check to see if it's bent, missing, or pushed down below the ice level, tricking it into thinking there's no ice
...bent arm, no power from dispenser to the solenoid are -some- possible trouble makers. Also the solenoid that controls the crush/cube function is probably frozen. First, pull out your ice bucket. On ...
...cube hung up again. Now I found that one of the 'teeth,' all the way to the right, was stuck under the housing... the part is bent, and needs to be replaced. Check the part that spins to make sure ...
...the ice tray or compartment is a wire shaft which runs to the control unit. Check to see if it is bent or obstructed by any object underneath it. If not then it is more than likely the control ...
onto it. Take the auger out and roll it on a flat surface noting the center axis. If it wobbles its bent
cube button has been pushed repeatedly I still get crushed ice instead of cubes. I have a frigidaire side by side. Thank You Sandy [email protected] your refrig has a solenoid that opens and closes
Question about Refrigerators
Must push the Ice Cube button really hard to get it to dispense ice cubes? The button probly has mold inside or the lifter has been bent from someone pressing it to hard
1,248 questions posted
Usually answered in minutes!
1,239 Questions
824 Questions
623 Questions
625 Questions
507 Questions