Canon PIXMA MP160 All-In-One InkJet Printer "mp470 print mode" Questions

mp470 print head when I just insert a new cartilage. No matter what I do, the printer error stating I didn't install the print head. Perform these steps and reset the EEPROM: Service Mode This printer

...MP470 Had a dell computer and PIXM MP 470 installed by the Geek Squad. The 470 works fine in the stand alone mode. It will print from my Word Wordprocessor; however, I can't get the scan function or ...

...Mp470 all in one printer, copier and scanner. I can not print because I can not get it out of the copy mode. How do I change it back so I can print? This may sound stupid, but I have tried everything ...

...mp470:1) Close the print head cover, and turn off the printer. While pressing the Resume/Cancel button, press the Power button. (Do not release the buttons. The LED lights in green to indicate that a ...

...mp470. 1. Disconnect the power cable 2. Connect it while holding down the power button 3. With the power button still down, press twice the "Cancel/Stop" red button 4. Release the power button 5. The ...

...MP470). 10. A test page should print. 11. Open the cover. - the cartridges should position themselves at the far left - the cartridge removal location. 12. Disconnect the power cable. 13. Remove both ...

Mode 3 is displayed. Press the OK Button Wait until "Without Cleaning" is displayed and then press the Stop/Reset button once. A test page should print. Open the cover. (the cartridges should position

mp470: 1) Close the print head cover, and turn off the printer. While pressing the Resume/Cancel button, press the Power button. (Do not release the buttons. The LED lights in green to indicate that a

...mode to reset the counter after replacing the ink absorbers. They are pads underneath the entire print engine for soaking up the waste ink. There are methods for reset posted here bu you risk an ...

...mp470 printer is stuck in copy mode and won't allow me to print anything. How do i undo this? If I need to install new drivers how do I do this and how do I know which drivers I already have? Thank ...