...Lid Lock Issue. For the FAV6800AW that is you machine type correct? The "LO" console error is "Lid has failed to unlock". I haven't experienced the "LO" error code to the display but this is the ...
Question about Maytag Neptune Washing Machines
...lid lock clicks several times when you try to start the wash cycle. The locked light never comes on and it just sits without starting. I disassembled the left locking switch and cleaned the contacts ...
Question about Maytag Neptune Washing Machines
...Lid Lock LED lit? If so further trouble shooting is required. I would next have you go into Service Mode. Once in Service Mode we need to go Board Output Test on page 16 of the Service Manual I will ...
...lid lock off and leave it off it?s not necessary for normal washer operation and we need to reduce the failure points for fault isolation causing the lid lock circuit to remain lit. Pull washer power ...
Question about Maytag Neptune Washing Machines
...lid lock back to the control board. 3. With spin only cycle selected and the lid closed press the Start Button do both lid locks try to close and lock the lid? From your initial post I believe you ...
lid lock to signal the control board that the ?Lid Is Locked?. Can you select Spin only cycle and press the start button ? do both lid locks close and lock the lid? If they did and you still take ?FL?
...lid lock, Left Lid Lock. You don?t need to replace the right just unplug. Here is what is happen. The left lid lock and right lid lock ?Lid is Locked? signaling are in parallel going back to the ...
Question about Maytag Neptune Washing Machines
...Lid takes long to lock once I hit lid locks or slam lids down it locks Once I slam the lid ! down ! then it locks and starts to wash it should start easily ,the lid switch may need to be ...
...lid lock keep flashing? changed lid lock but having the same problem. There is a right lid lock and a left lid lock which did you change? The left lid lock is a lock and the reed switch which tells ...
Question about Maytag Neptune Washing Machines
...Lid Lock assembly. If you remove the Left Hand lid lock assembly I believe you will find a broken wire to the magnetic read relay or severe corrosion on the input and output pins in the Left Hand Lid ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions