wont close all the way. Do I replace the replace the lock mechanism module? If the interlock isn't working it may not allow the machine to start. If you can open the door when it should be locked it's
...wont do anything but beep at me. What should i do?? Hello, The LO error code means the LID OPEN Here is what the techicians service manual say to check LO Door failed to unlock Door lock monitor ...
...door wont lock. During a wash cycle the water just started comming out of the door. If I hold the stop/start button manually the light still wont come on but the water will drain out properly. Tried ...
...door wont lock and so it wont do a spin cycle to ring out the clothes. When the door lock fails, there is a part on the electronic control board that fails (resistor burns up). Both will have to be ...
Maytag Neptune Washer, Model: MAH5500 The door does'nt lock and it does't spin. The problem is with your door lock set.You may need to replace it.If your lock is faulty the washer wont begin its cycle
replace door door wont lock check the door pin and the lock
...MY WASHERS DOOR WONT LOCK BUT WILL START FILLING AND ROTATING BRIEFLY BUT NO WASH OR SPIN CYCLE BUT WILL RINCE IS IT THE DOOR INTERLOCK SYSTEM OR WHAT PLEASE HELP. Try some WD40 on the door
Question about Maytag Neptune Washing Machines
...operate displaying "d o" but is locked was locked earlier but found cord to unlock now still wont operate displaying "door open (d o)" is closed tightly ??? Replace the wax motor switch in the
...wont be able to lock.In this case you do have to change the "Door Latch Assembly". Please rate this !!! Mechanics at door appear ok, lock light remains dark, washer won't spin. Front load #mah3000aww ...
door wont stay locked to run a load I shut the door and hit start and the machine starts to cycle then a couple of seconds later it shuts off and door is unlocked - I checked the door and when it says
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions