Maytag MSD2454G Side by Side Refrigerator "turn blinking control light" Questions

...blinking but there are no alarms or error codes displayed, it may indicate a problem with the refrigerator's control board or power supply. Here are some steps you can take to troubleshoot the issue: ...

...turn it back on again. If the blinking light persists, it may indicate a more significant problem with the freezer, and it is recommended to seek assistance from a professional appliance repair ...

Blinking lights ice and water do not dispense water. The lights go out when dispenser activated. Temperature settings just blink 0000 digits. pcb problems This is most likely the control board behind ...

...blinking and the fridge does not cool effectively,. More than likely, your Circuit Control Board has now gone bad... There are few troubleshooting steps but I would recommend calling a Professional ...

on/off lights are blinking. Freezer working but fan wont blow coldair to fridge. Fan is just barely turning and not frozn to anything. Good day, Have you tried to check on the door switch? it actually

...turn it off then on, that the red light next to the on/off switch is blinking. Does anyone know what this light is for and if it is telling me what is wrong? I regularly change my filter and I am ...

...turn off the filter light after a new water filter is installed According to the users manual just follow the following steps. To reset the CHANGE FILTER light: Press and hold the LIGHT and LOCK pads ...

...on one light on freezer was blinking Turned it off for a minute and still didn't work. control board will not respond Does it show any fault code. Possible freezer is not cold. Let it run for 24 ...

...control light is blinking red. press the button that turns light on and off 5 times and it should reset filter life but you should get new filter if it does not reset look in manual to reset ...

...blinking light . Now it wont come on at all. I have a freezer full of beef!! what can i do? Need more info. Is there a control panel? if so, try turning off and on using the panel. Do you have an ...