...test the washer. If the F2 is still displayed, then the user interface control board will need to be replaced. CLICK ON THIS LINK TO GET THE INSTRUCTIONS HOW TO REMOVE CONTROL BOARD:-- ...
...Test mode to verify repair. 4. If replacing the user interface assembly failed: Unplug washer or disconnect power. Replace the machine/motor control assembly. Plug in washer or reconnect power. ...
...user interface board. Run the console and indicators diagnostic test mode to find out. Console and Indicators Diagnostic Test Mode Activation While in standby mode press the following button sequence ...
Question about Whirlpool Washing Machines
...user interface board) The machine stores the last 4 error codes--keep momentarily pressing the spin button to see any stored codes until the machine displays a C0. Image 3 has the instructions. The ...
...not rectified by user. (You can check the fluff filter but you can not test the motor or electronic board.)You need to get professional help from Miele for proper diagnose and solution for it.
Test Mode per the Tech Sheet. 2). Did the Right Hand Interface light up? 3). IF the Right Hand Interface did not light up in Step 2 check for 5 VDC on the UIP3 wire connector coming off of the control
...Test mode to verify repair. 4. If replacing the user interface assembly failed: Unplug washer or disconnect power. Replace the machine/motor control assembly. Plug in washer or reconnect power. ...
Question about Indesit Washing Machines
the console and reconnect power. Run the diagnostic test once again. Replace the user interface board if it fails the test once more.Refer to the next post if no problem is found on the user interface
Question about Kenmore Washing Machines
...test the washer. If the F2 is still displayed, then the user interface control board will need to be replaced. CLICK ON THIS LINK TO GET THE INSTRUCTIONS HOW TO REMOVE CONTROL BOARD:-- ...
...test to see which one is faulty. Here is the actual tech manual instructions for that code:PROCEDURE: Before proceeding, press OFF, OFF, START to enter Diagnostic mode and verify the error codes. ...
1,189 questions posted
Usually answered in minutes!
100 Questions
91 Questions
15 Questions
3 Questions