...cycle. Drum bearing failure is common when the bearing seals start allowing water to enter. You can take the belt off and spin the drum by hand, and if the drum rumbles, replace the bearings. ...
...spin cycle. The drum spins and the agitator spins until the end of the spin cyle. At this point the drum spins, but the agitator stops spinning and there is a knocking noise. HELP! Open the washer in ...
...spin in rinse. With drum empty, it will spin. Removed cloths, rung dry by hand and returned to drum. Still would not spin, but I could see a light movement in drum. Gave a little assistance to get ...
Question about Frigidaire Washing Machines
...drum does not spin freely (resistance, stops after less than a revolution), and still has the squeak. Drum has a little movement front to back, not up when I push up in the middle of the drum. Does ...
Question about Maytag Washing Machines
...Spin cycle drum winds down slowly- Doesn't stop w/LID opened The drum does not stop abruptly when the lid is opened during the Spin cycle like it always has in the past. The power to spin the drum is ...
buttons simultaneously, press the "Start/Pause" button twice. Does the drum spin slowly? If not, it could mean that the stator assembly of the motor is faulty or that the main PWB board may be faulty
Question about Frigidaire Washing Machines
drum and will spin what's the matter Candy1682d/180 will not spin with clothes in drum, empty drum and will spin what's the matter Hello - Does the unit make a humming noise? If so, either
...drum won't spin Kenmore Heavy Duty Plus Dryer 86273100 drum won't spin How could the belt be in working order if the drum doesn't spin? Check to see if the belt has come off the motor. If the ...
Question about Kenmore Washing Machines
...drum does not spin. I think it may be the 5307d solenoid(?) and if so, where do I get one in Australia? It seems to have run a complete cycle but laundry still wet although there is no water in the ...
Question about Washing Machines
drum. Spins freely, washes fine, just on spin the noise. Purchased in 2008 with no extended warranty. Could be a bad bearing or something loose on the drum that doesn't rattle until you get up to spin
128 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions