Question about Kenmore Elite Washing Machines
the console and reconnect power. Run the diagnostic test once again. Replace the user interface board if it fails the test once more.Refer to the next post if no problem is found on the user interface
...test the washer. If the F2 is still displayed, then the user interface control board will need to be replaced. CLICK ON THIS LINK TO GET THE INSTRUCTIONS HOW TO REMOVE CONTROL BOARD:-- ...
Question about Kenmore Elite Washing Machines
...user control and display board may be defective. Check for power to the washer first. Timer If the washer won't start the timer might be defective. This part is often misdiagnosed, check other ...
...user Interface.NOTE: This is a quick test you can try to get to a quick resolution, but remember if the Lock Light does not blink once the power button is pressed you will need to follow the standard ...
Question about Kenmore Elite Washing Machines
...Test mode to verify repair. 4. If replacing the user interface assembly failed: Unplug washer or disconnect power. Replace the machine/motor control assembly. Plug in washer or reconnect power. ...
...Test mode to verify repair. 4. If replacing the user interface assembly failed: Unplug washer or disconnect power. Replace the machine/motor control assembly. Plug in washer or reconnect power. ...
...user interface board. Run the console and indicators diagnostic test mode to find out. Console and Indicators Diagnostic Test Mode Activation While in standby mode press the following button sequence ...
Question about Kenmore Elite Washing Machines
Test Mode per the Tech Sheet. 2). Did the Right Hand Interface light up? 3). IF the Right Hand Interface did not light up in Step 2 check for 5 VDC on the UIP3 wire connector coming off of the control
...Test mode to verify repair. 4. If replacing the user interface assembly failed: Unplug washer or disconnect power. Replace the machine/motor control assembly. Plug in washer or reconnect power. ...
...test to see which one is faulty. Here is the actual tech manual instructions for that code:PROCEDURE: Before proceeding, press OFF, OFF, START to enter Diagnostic mode and verify the error codes. ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions