...or use the third wire to act as jumper between the two. After this if the problem is solved then replacing lid switch is recommended repair. Please get back to me if you have any other questions. ...
...lid switch. It is very easy to repair. To test it watch the video.Older models would wash with the lid open but not spin. This later model washer won39;t wash or spin with the lid open so I suspect ...
...but it won39;t close the circuit 2. the screw holes snap and it hangs off the wires, the probe no longer hits the paddle and the switch stays open. The lid switch is cheap and very easy to
...repair the washer. The part number for that valve is 285805 it could be purchased at your local applinace parts store or online at; searspartsdirect.com apdepot.com repairclinic.com apwagner.com ...
...or use the third wire to act as jumper between the two. After this if the problem is solved then replacing lid switch is recommended repair. Please get back to me if you have any other questions. ...
...more lid switch/fuse assamblies in 30 year appliance repair career that i can remember. I dare say (by assumption) that the tech that came to diagnose your washer gave you the exact correct ...
Question about Kenmore Washing Machines
...lid switch. I refurbish and repair appliances for a living and I warranty for life - I bypass these switches all the time. If you need help opening the control panel and/or doing the ...
Question about Hotpoint Washing Machines
won39;t spin the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Test any electrical switches with an Ohm
...repair clinic.com Some machines have a special lid-switch fuse near the lid switch, inside the control panel. If this fuse blows, the unit won39;t fill with water until you replace the fuse. or it ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions