...post back if you need further assistance. Dispenser Circuit Error If the dispenser motor is not able to be driven to it?s proper position. Potential Causes ? Check mechanical linkage from dispenser ...
Question about Kenmore Elite Washing Machines
Dispenser" heading as item number 1. The replacement is very simple if you follow these steps: 1. UNPLUG the washer and turn off water supply. 2. Remove both fill hoses. 3. Remove the top panel of the
post back if you can determine where the leak is coming from. HELPFUL HINT: Put the washer into diagnostics mode if you plan to leak test. At the control panel select DRAIN/SPIN, NO SPIN and press any
...post. thanks. I've been looking too. And finally found it! john_in_erie Rank: Apprentice Rating: 98%, 12 votes Replacing gasket is fairly simple - need 2 people. UNPLUG FIRST - 1. Remove the plastic ...
...dispenser motor. Replacement parts (if required) can be purchased at any of the following websites: searspartrsdirect.com pcappliancerepair.com appliancepartspros.com repairclinic.com Prices vary ...
...dispenser drawer and close. Then, you press the "Control On" button followed by the "Hold to Start" button. NOTE: If you fail to press "Hold to Start" within 5 minutes, the washer will shut off. All ...
...dispenser snapped on top of the center post. If you are having problems with the fabric softener not dispensing, you simply pop the cap off the center post and wash and rinse in some hot water to ...
...post cap or fabric softener dispenser (if equipped) from the agitator by gently prying it off. 2. Under the center post cap locate the air gap plastic cap (if equipped) and remove. 3. Remove the ...
Question about Kenmore Washing Machines
...dispenser (if installed) from the agitator center post. There should be another cap (used as an air gap) under the center post cap. Remove the cap and locate the agitator bolt. Using a socket and ...
...dispenser from the top of the agitator. It should just pop off. 2. Locate the white plastic cap underneath and pull straight up to remove. 3. Locate the agitator bolt underneath and remove using a ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions