low. (sensor pressure). The drain motor does not work - Test and if faulty change the drain pumpMessage = E9 Error = SENSOR PRESSURE ERROR Cause & Solution = The water level sensor is faulty
...low water flow H/T shutdown problem by turning the water flow sensor exactly vertical so that the paddle wheel is directly above the hose). Is there supposed to be any visible water in the bottom of ...
fix washing machine lights are on, will not fill with water. Reset level selector by turning to low and back up to desired Try hot and try cold. See if either one will fill/partial fill. Try rinse Try
Question about Kenmore Washing Machines
...low level, or other, and it still just fills. Frustrated. Inside the case there is a water level switch. It is round, has 2 wires to a number of connectors and a tube that goes down to the drum. As ...
Question about Kenmore Elite Washing Machines
...low water level. This particular machine is supposed to detect the condition and report the problem, but in some case that may not happen because the vibration sensor is not functioning correctly. ...
...Until the maintenance person can find and fix the leak or pump issue, a washer with sensor like this that detects how long it takes to fill the tub will give the low flow error and stop
...low and so could trip.secondly it can be due to problems in the level sensor, try and see if the pressure switch works outside.Finally check on the program controller unit once again to ...
Question about Washing Machines
...sensor using a multimeter to see if it is sending the correct signal to the control board. Check the drain pump: If the drain pump is not working properly, it can cause water to pump out in pulses or ...
Question about LG Washing Machines
fix this? The water level sensor is a pressure sensor that reeds a vary low pressure inches of water column. There is a little clear plastic tube (hose) that runs from a hose barb on the bottom of the
Question about AEG Washing Machines
...fix it and how much C1 is fault in prewash cycle and means no water inlet. Could be: vaIve does not open or interruption, flow rate to low. So, I suggest to check an following parts: water inlet, ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions