temperature. Since the thermistor is open (infinite resistance), the electronic control board "thinks" the dryer temperature is too low. It then activates the heater relay continuously which makes the
...thermal fuse blows (opens) when the temperature is above the set value. When is blows it will have to be replaced before the circuit is operational again. A thermal switch deactivates the ...
...open at room temperature needs to be replaced. Hope this helps? Components in blue box are the thermal cutoff fuses Parts below are used in the heater assembly to control the heater maximum ...
...temperature. Failure of the thermal fuse results in the motor not running and the dryer not working at all. Remove the dryer real panel to access the blower housing and check the continuity of the ...
...open. All thermostats and thermal fuses should be closed for continuity at room temperature on this dryer. Go here for more Maytag Atlantis Dryer repair help: http://www.repairclinic.com/0047_8.asp ...
...Thermal fuses are of several types. 1 I see most often looks like a "transistor" and has a wire coming off each end. Looking closely at your fuse see if you can get any numbers off of it. These are ...
opens at around 160 degrees to allow the dryer to cool back down during operation. If the cycling thermostat is bad, it will allow the dryer to reach a temperature high enough to blow the thermal fuse
...temperature is too low. Hello there: Investigate these five areas if your dryer is not heating up: Proper Voltage If your dryer won't heat up, it's possible that it is not being supplied with the ...
temperature selections. Is the shutoff valve in the gas supply line open? The drum of a gas dryer will turn, but the dryer will not heat, if the gas shutoff valve is closed. Open the gas shutoff valve
46 questions posted
Usually answered in minutes!
1,329 Questions
1,410 Questions
750 Questions
524 Questions
182 Questions
