the cover cap firmly. Run a short wash cycle and check for any leaks at the filter cover cap. If the error comes back, you may need to replace your drain pump. Replace the kick panel if none are found
...pump cap and clear out whatever is blocking the pump (lint/loose change etc. that might be stuck there). However, I cannot open the pump cap? I can turn it about a 1/4 circle and then it does not ...
...cap of the pump,with a shop vac vac up any water that leaks out until it stops and then remove the cap,stick your finger in the pump and make sure nothing is hitting the impellar,most of the time ...
...pump it has a threaded cap faceing the front remove this cap and clean out the lint trap attached clean out and debree in the pump housing you can see. reinstall cap, front cover, plug in and
pump cap turns but will not pul out. drain pump cap turns but will not pull out. had grips on cap,it does not appear to turn fully assumed cap has to be horizontal to pull out. Make sure that you have
of the filter does not correct the spin out, this will confirm that the issues are serious and it will isolate the motor control board as the lone culprit. Here is a picture of the filter cap and pump
...cap. its the problem in the pump and something is getting blocked in the pump so water is not getting out. Front-Loading Whirlpool Washers Unplug the washer. Remove the three screws along the bottom ...
...pump clean out cap. Remove the cap (Water will come out) and see if there is something plugging the pump. Make sure there is nothing in the impellers. If the pump is clean, Turn the water off to the ...
cap, unscrew it and remove the debris in the pump and all should be well. You might want to tart by tippint the machine almost onto its back so the water doesn't come rushing out when you undo the cap
675 questions posted
Usually answered in minutes!