Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "saw getting fuel firing" Questions

...Pull the hose out and on the end of it is the fuel filter. Chances are it needs replaced. If the saw is getting fire but won't start it has to be a fuel problem. That is where you need to start ...

fuel but will not fire Cannot get the saw to fire, has a new plug with good spark, put a little fuel straight into the spark plug hole but will not fire. check the compression I found a critter made a

saw will not fire. It has good compression, good spark, and it is getting fuel. Any ideas. Thanks Hi Check if the gas tank cap vent is plugged.Check if the flyweel key is sheared(ignition timing point

...fuel system. Saw starts after too many pulls and runs, but will not come up to operating RPM. Acts like it is struggling to get fuel, just like it did before the carb overhaul. Saw was running fine ...

...saw was left away with fuel in the carburettor for a few months it's possible that gel has formed in the jets which block the fuel getting through. If this is the case and the above procedure didn't ...

...Have you tried cleaning the air filter? The carburetor fuel inlet may have screens plugged with sawdust as well. If you have spark and fuel and AIR you should get fire(combustion) ...

saw with fuel in it and subsequently had to replace the primer bulb, and fuel pick up line and also cleaned air filter. After replacing, saw fired right up with no problems. I ran a tank and a half of

...saw was running fine until the carb came loose on the barrel but I have been unsucessful at getting it to run since I have replaced the gasket between the carb and cylinder. it probably damaged the ...

saw to start, I have changed the fuel, fuel line, filter, carb, and checked and I am getting good fire sounds like trash on jets remove carb and clean and rebuild it Check the obvious first, check the

...saw won't start.acts like it's not getting fire but has real good blue fire.so figured must not b getting fuel SO poured fuel into carb and nothing.does anyone have any other ideas cause I always ...