Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "module gap" Questions

...module pole gap with the flywheel magnets just under the module poles using a thin business card for a gap gauge. Insert the card and loosen the module mounting screws to allow the module to contact ...

...gap at the module--access the flywheel/module area again and turn the flywheel magnets under the module poles. Insert a thin business card into the pole gaps, loosen the module mounting screws and ...

...module pole gap by turning the flywheel magnets under the module, insert a thin business card into the pole gaps, loosen the module screws to allow the module to contact the magnets. Tighten the ...

...module pole gap by turning the flywheel magnets under the module poles, insert a thin business card into the gaps, and loosen the module screws to allow the module to contact the magnets. Tighten the ...

...module gap Turn the flywheel magnets just under the module poles, insert a thin business card into the pole gaps, and allow the module to contact the magnets. Tighten the module screws and rotate the ...

...module using a thin business card for a gap gauge. Turn the flywheel magnets under the module poles, insert the card into the pole gaps, loosen the module screws to allow the module to contact the ...

module pole gap using a thin business card for a gauge--turn the flywheel magnets (after removing the side case) underneath the module, insert the card into the pole gaps, loosen the module screws and

module pole gap to the flywheel magnets with a thin business card for a gauge. If the gap is excessive, that can give a weak spark. If the gap appears to be correct, then it is probably time for a new

...gap between the ignition module and flywheel on a craftsman chainsaw? Are all saws the same? rebuilt carb, new ignition module, new plug,but no spark. is there a "gap" between the ignition ...

...gap gauge. Turn the flywheel magnets under the ignition module poles, insert the card into the gaps, loosen the module screws and allow the poles to contact the magnets. Reset the screws and try for ...