...transmission fluid. It was about as black as the oil was. They told me that it was extremely dirty, and that I should have the transmission flushed. They suggested: Change the transmission filter and ...
...transmission. Regards, Tony You can check oil level of your 2004 Chevrolet Malibu as described below. If the engine is the 2.2L Ecotec 4 cylinder engine it uses a canister filter (Fram # PH9018 I ...
Question about Chevrolet Malibu
...transmission fluid in chevy malibu 2012?? car has 72000 miles transmission oil has not been replaced. mostly to drain transmission oil it is necessary to remove the pan. At 72000miles I suggest that ...
...transmission filter on my 01 malibu Jack up car to work under it. remove bolts on pan just enough to drain oil from it, the best way is to remove the bolts until oil runs from the corner of the pan. ...
Question about Chevrolet Malibu
...replace the blots and torque to 14 inch lbs.at the top of the transmission their should be a red or black fill plug . add 4 quarts of fluid to the transmission through this hole . start the car and ...
...transmission pan and change the filter and replace the fluid that is lost,however there will still be old fluid left in the torque converter. now if you have a manual transmission it is a sealed unit ...
...replace a transmission at 1200 dollars the little things help in the longrun. hope this helps let me know good luck It SHOULD be done, since it is not meant to last more than 100,000 miles-the ...
Question about Chevrolet Malibu
i need to change transaxel fluid and filter,and refill. thanks remove mounting screws and lower transmission pan. Remove mounting screws (if any) and remove the filter. replace reverse of removal.
...transmission pump. Sometimes they have a high pitch whine noise yet nothing wrong its normal. Sometimes its an indication of the pump being over-worked due to a dirty filter or fluid low. Turn engine ...
...Replace the filter, clean the pan/transmission mating surface with emery cloth, scuff pad, or whatever needs to be used to get the metal clean again (without removing too much material eg. a grinder ...
362 questions posted
Usually answered in minutes!
1,306 Questions
1,257 Questions
1,094 Questions
1,067 Questions
997 Questions