Question about Chevrolet Aveo
...TCM substitutes default values for engine speed, throttle position, and other engine data signals. • Transmission operation will be reduced, affecting shift points, torque converter clutch operation, ...
...messages cleared up by cleaning up the ground contacts for the TCM and even one fella had some luck replacing the speed control sensor in his and the lights all went away and it ran fine after
speed of the vehicle. Symptoms: You will likely not notice any drivability problems other than the MIL illumination. Causes: A code P0128 may mean that one or more of the following has happened: * Low
...TCM DTC P0725 - ENGINE SPEED SENSOR CIRCUIT When Monitored: Continuously after a ignition key is turned from the OFF to RUN position and/or key is turned from the CRANK to the RUN position. Set ...
Question about GMC Cars & Trucks
...TCM harness connector. Disconnect the input speed sensor (ISS) from the control solenoid (w/body and TCM) valve assembly. Connect the J 38522 between the supply voltage terminal B and ISS signal ...
...Speed Automatic Transmission Assembly For 2012 Chevrolet Impala so next where is the brain here TCM ( by any name) zero hits at chevy for TCM) ECM yes, BCM yes. seen here and CHEVY does not sell he ...
Question about Cadillac Cars & Trucks
...TCM detects no input shaft speed when there is vehicle speed in a drive gear range, then DTC P0717 sets. DTC P0717 is a type B DTC. I bet it does shift crazy ! Diagnostic Aids Ensure the ISS is ...
...speed sensor (VSS) Cause Wiring, VSS, TCM P0710 - Nissan Type Powertrain - Transmission - ISO/SAE Controlled Description Transmission fluid temperature sensor - excessively high or low voltage Cause ...
...TCM code p 0717 refers to turbine shaft speed (TSS) sensor ---no signal====causes ---wiring---TSS sensor---ECM/TCM logically the TSS reports to the TCM to facilitate ratio changes so if the wiring , ...
...Speed Sensor 1 Circuit P0715 is detected when TCM or ECM does not receive the proper signal from the sensor. The input speed sensor detects the primary pulley revolution speed and sends a signal to ...
216 questions posted
Usually answered in minutes!
754 Questions
686 Questions
491 Questions
178 Questions
198 Questions