KitchenAid K45SS Classic Stand Mixer "governor" Questions

Ad

my governor assembly is broken and the speed controller does not work a piece of the governor assembly was broken and inside the back part of the mixer. Since tehn the mixer speed controller does not ...

Ad

Question about KitchenAid Food Mixers

1 Answer

...speed control works: Speed Control The speed control of the mixer is attained through the use of a governor assembly mounted at the rear of the control plate assembly. The electrical circuit is made ...

Ad

...US into Europe. Not aware of the 110/220v issue, I plugged it in and caused a short-circuit. The governor screw of the device came apart during the incident. I ordered a new governor as well as a ...

Question about KitchenAid Food Mixers

1 Answer

...all speeds, odd..... plugged everything back together, now it runs fine until..... one side of the governor assy. comes loose, enough that it rubbed away part of the circuit board, is it a defect in ...

Question about KitchenAid Food Mixers

1 Answer

...long, so I don't think that is the problem. I have the same mixer and I believe your problem is the governor that is on the back of the motor. You can figure it out by downloading the repair manual ...

Question about KitchenAid Food Mixers

1 Answer

speed control is erratic while under load I'm going to say the first thing to check is the speed governor. You'll see it when you take the rear cap off- it's behind the plate that's mounted on three ...

Question about KitchenAid Food Mixers

2 Answers

...on low speed, then has only one higher speed It sounds like you may have an issue with either the governor assembly and or the main control. If the speed you are getting is constantly going up an ...

Question about KitchenAid Food Mixers

1 Answer

...speed my kitchen aid mixer speed up suddenly bought from Sams Club It sounds like you may have a governor issue. which is located at the back of your unit. it controls the amount of current going ...

Question about KitchenAid Food Mixers

1 Answer

...literature/Repair%20Part%20List%20-%208212369.pdf The speed is controlled with a combination of the governor assembly #24 which mounts on the motor shaft, and the phase control board #27 which is ...

How do I replace the governor on a kitchenaid mixer KSM150PSBK With two screwdrivers, you can carefully pry off the governor assembly. Be careful no to bend, remove the governor drive stud and lay it ...

Not finding what you are looking for?
KitchenAid K45SS Classic Stand Mixer Logo

613 questions posted

Ask a Question

Usually answered in minutes!

Top KitchenAid Food Mixers Experts

Appliance engineer

Level 2 Expert

189 Answers

CJ C
CJ C

Level 2 Expert

66 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a KitchenAid Food Mixer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...