2006 Holiday Rambler Presidential won't run 12 volt system without shore power. Battery good. Battery switch good. Auto reset breakers good.

Question moved to Holiday Rambler.

Limited help here, but you probably need dealer help.

https://www.google.com/search?q=Holiday+Rambler+Imperial-Firestone+IntelliRide+system+does+not+light+up

..

Question edited to add maker name.
Question moved from Computers and Internet Category!

Upping the cable by 20 amps is not the way to fix a power drain. Probably damage to the inverter unit

Wiring diagrams in the link. If you click on the All tab in the Google link, there is a video on how RV electrics work.

https://www.irv2.com/forums/f50/1982-holiday-rambler-presidential-32-wiring-schematic-492921.html


https://www.google.com/search?q=2005+presidential+5th+wheel+electrical+wiring+diagram&rlz=1C1QJDB_enCA643CA644&sxsrf=APq-WBuJcD4ICEbjyXL-VsAJBjy7zFb8Hg:1648605300744&tbm=isch&source=iu&ictx=1&vet=1&fir=KrKNJ6HiydzOqM%252Ca040EHa8677DXM%252C_%253BPKxF3hbLq-nFUM%252CPclodYzkeRuhQM%252C_%253B22DuNBhvFLw4hM%252CVjlk_so_xvU_DM%252C_%253BI8x4cqxHW7WtTM%252CTeTnAjxF6YF-IM%252C_%253Bu9-IU_9gaGeliM%252C8VmY7GTToPGslM%252C_%253BvfeA6ssBY0mUVM%252C7VB6oI2t8KHr_M%252C_%253BnIJVnekL5kPHVM%252C61T3T4fM8g9o2M%252C_%253B1tKtFF2B4V7GGM%252Ch_n7r6s8msFMqM%252C_%253BsXRI5gQpNYfJPM%252CnKk3NKLOOPwwrM%252C_%253BEwNSF8coq8os9M%252CWytUIwpciEyMGM%252C_&usg=AI4_-kQe_WLL2J8bkmQgOSMo-Lu-y4qYZg&sa=X&ved=2ahUKEwii78yq3ez2AhXDVc0KHSK1Cg4Q9QF6BAgCEAE#imgrc=PKxF3hbLq-nFUM

...

pipes to the water tank or cracked or rub holes in the tank from the straps

If it is wired for 220, maybe, but if not it may blow your converter/charger. Most RVs aren't set up for 220 straight into the system.

You need to get to the motor and see if there is power going to it in both directions. Does it sound like the motor is running but nothing moving?

There is probably a breaker box in the bedroom closet behind a panel. Look elsewhere if not there and check the breakers when you find it. You may have a short circuit somewhere and the breaker opened. Or maybe even a failed breaker. Check for voltage at the breaker itself. Don't assume the breaker is getting power.

there should be a switch by the door. if does not work. check 12 volt power supply if not hooked up to shore power. u can manually crank it out from underneath.

120-
VOLT
AC
SYSTEM
The following electrical components (if so equipped) will only operate when your
RV is connected to shore power: 120 to
12-volt power converter, air conditioner,
120-volt refrigerator, microwave oven, television(s), fireplace and appliances
plugged into convenience receptacles.

SECTION 6 - ELECTRICAL SYSTEM JAYCO TOWABLE
6-2
120-
VOLT
CIRCUIT
BREAKERS
The 120-volt AC circuit breakers located in
side the main load center protect all
120-volt wiring and components in the RV fr
om circuit overloads and short circuits.
Should a circuit overload or short circui
t occur the circuit breaker protecting the
affected circuit will "trip" preventing the flow of electricity through that circuit.
If a circuit breaker trips, shut "off"
the appliance on that circuit (i.e., power
converter etc.) and allow the circuit breaker to cool down for a brief period of time.
After the cooling down period, reset the circuit breaker by moving its lever "off" and
then back to the "on" position. If the circuit breaker re-trips or frequently trips,
contact your dealer to have the electrical problem diagnosed and repaired.
A circuit breaker identification label is permanently attached to the inside surface
of the 120-volt load center.
Maintenance and Replacement
At the beginning of camping season, inspect the circuit breakers and replace as
needed. Test by turning each circuit breaker "off" and back "on". Circuit breakers
are wearable parts and must be replaced
as needed, as part of your RV
maintenance. If you have any questions, consult your dealer.
Please contact your dealer for repair assistance when replacing circuit breakers.
CONVERTER
The power converter converts 120-volt AC power to useable 12-volt DC power
when the shore power cord is connected to an external power source.
The converter has a built-in protective thermal breaker that will shut it down should
overheating occur. Overheating can be
caused by operating the converter above
its maximum power output for an extended period of time, or by an obstruction to
its ventilation air flow. To reduce converter heat build keep unnecessary 12-volt
lights and motors turned "off"
.
Keep the converter cooling fins and fan clear of
obstructions.
Inspection and maintenance
If the 12-volt power converter is not working (auxiliary battery not being charged)
check the reverse polarity fuse(s) in the converter fuse panel.
There are no
customer serviceable parts inside the converter case and the
manufacturer's warranty will be void if
the case has been removed
. If you
have further concerns contact your dealer.