Manually push it out. See manual as to how to do this, then the switch to draw it back in
Since I am not familiar with this you will have to tell me what the red light is for. If it indicates the slide out is out, then you have a bad limit switch. If it indicated there is a problem, then it is possible an over current condition exists because the slide is jammed
SOURCE: No picture no sound
There are lights on the board about 8 you should look at which comes on and which stay on this by hitachi standards tells you what is wrong. Most of the time its convergence amps bad.
SOURCE: I can't get the light to come on.
Sounds like your black screen shutter is not opening allowing light to pass through. Try it with the carousel and slides installed. Run a few passes.
SOURCE: click when plugged in and steady blinking red light.
hello it sounds like it could be just a dry joint on the video section of the tv good luck
shaun
SOURCE: 2 way light switch tripping breaker
connected wrongly on one switch or neurtal wire is present at one box is shortening,thus tripping
SOURCE: when hit switch pto won,t come on
check the 2 wire conection under the frame near the pto clutch, motor off of course. Make um tight.
152 views
Usually answered in minutes!
×