Why not turn on something on that battery circuit and then try the switch in either position? The battery systems (chassis and house) are generally left ON when using the RV or connected to shore power. If in storage without shore power, then the disconnect switches will reduce battery drain.
SOURCE: driver door panel removal and re-connect door pull
You most likley have a damaged inside door handle. To remove the door panel, you must first remove the handle bezel. The trim piece around the handle. It is held in place by 4 retainer tabs, take a small flat screw driver, insert it between the bezel and handle. Gently pry away from the handle. If you look in the crack around the handle you will see the tabs. When you get that off, remove the switch assembly by prying up on it gently, unplug the wiring. There are 2 screws in the door panel where you pull the door shut, remove those also. Start at the bottom front of the door panel, pull outward firmly, but not violent. The retainers will come out, you will most likley break some, this is common. The inside handle is about $45 from your dealer. If it is the handle it is held in with 1 rivit, drill it out with a 3/16 drill. Replace the handle, reassemble. Good Luck.
SOURCE: Where can I find a manual for a 2008 rockwood signature ultra lite camper
Go to www.rockwoodcamper.com and send a request for a manual to customer service.
197 views
Usually answered in minutes!
×