20 Most Recent Winnebago 2008 Voyage 32H Questions & Answers


My first two suggestions are related to the ignition switch and the gauge cluster. I like to try a "wiggle test". Sometimes it is a great way to narrow down a search. Put the key in the ignition and turn the key to the run position (do not start the engine) and wiggle the key and turn or rock the key slightly. You want to see if maybe the ignition switch if faulty. If you notice nothing from this test then it may be fine. Next would be to remove the gauge cluster and inspect the harnesses that plug into the back side of the unit. Over time dust can work itself into connections and cause havoc on circuits or systems. I will say that from your description, it sounds like a soldered joint, loose or over-heated wire is related to this problem. At this time I can not give you a good recommendation. I can tell you that somewhere where, something has worn out. It could be related to wiring, the fuse box, ignition switch, gauge cluster, or ECU. Please write back with more questions or findings. Please be as specific and detailed as you can. I hope to hear from you soon, good luck.

Winnebago 2008... | Answered on Feb 22, 2018


Sounds like there may be a loose ground wire from the instrument cluster to a metal chassis point.

Winnebago 2008... | Answered on Feb 06, 2018


http://www.classicwinnebagos.com/forum/index.php?PHPSESSID=f64101c1c6919d666ec4d10beb9bcfc3&action=store;sa=view;id=193

Winnebago 2008... | Answered on Feb 06, 2018


1) check and see if your car has a good earthing cable.
20 it could be a loose terminal or fuse.

Winnebago 2008... | Answered on Feb 06, 2018


Your local auto parts should be able to give that to you. You may also be able to set up an account at oreilly auto parts online and access the torques specs there.

Winnebago RVs | Answered on Feb 06, 2018


next to water pump inside of where you fill it

RVs | Answered on Jan 16, 2020


make sure pressure released then pump should come on if not just inside where water is filled in tank should be a panel or divider to remove to access pump check inline fuse if bad possible water was froze last time turned on

RVs | Answered on Dec 29, 2019


We purchased EEZTire-TPMS for our new 33' travel trailer right before a 4500 mile trip through the upper Midwest to the Washington coast, so lots of different terrain. We experienced snow, freezing rain, dust, salt water and the temperature extremes associated. These monitored the pressures and temperatures very well.

The distance from the monitoring unit to the sensors was about 25ft and connected well. We did occasionally see a short disconnect with one sensor (maybe twice during the trip) that resolved after about 20 min. Overall these have worked Very well and I would recommend them to all RV travelers.
If you want detailed reviews about best rv tire pressure monitoring system, you can check this: https://www.rvtalk.net/best-rv-tire-pressure-monitoring-system-reviews/

RVs | Answered on Dec 19, 2019


If you're having issues with the slide mechanism, figure out the manufacturer of the slide and Google it for a troubleshooting guide and repair manual. Their website will often have instructions for manual retraction or extension.

RVs | Answered on Nov 07, 2019


Contact the manufacturer/distributor directly to request the manual.

RVs | Answered on Nov 04, 2019


I can only suggest to try a dealer....EBAY...Amazon or even try Craigslist. Surely someone has one. Good Luck!

RVs | Answered on Nov 02, 2019


I would start by checking your 12 volt battery voltage, should be 12.5 to 12.8 voltage reading, as with out it the heater will run briefly and then shut down. There are many factory trouble shooting guides on line for free. Not sure if you have a ATWOOD Suburban heater?
Normally if the fan motor comes on... it blows against a flat plate called a flail switch. That switch tells the ignition device to give spark to the GAS CHAMBER. So my guess is....with your start stop condition....the the electronic control is not working correctly due to low battery voltage. As you said....when on 120 volts going to the 12volt invertor...things work correctly. Lots of information on U-Tube on furnace troubleshooting! Good Luck Goodn

RVs | Answered on Nov 02, 2019


Contact Komfort directly to request the manual.

RVs | Answered on Oct 28, 2019


usually close to the storage tank

RVs | Answered on Oct 25, 2019

Not finding what you are looking for?
Winnebago 2008 Voyage 32H Logo

5 questions posted

Ask a Question

Usually answered in minutes!

Top Winnebago RVs Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

pawnpower

Level 3 Expert

851 Answers

john h

Level 3 Expert

22486 Answers

Are you a Winnebago RVs Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Voyage 32H Winnebago

  • Voyage 32H Winnebago

Most Popular Question

7500 quiet diesel genset code 46 clear

  • RVs
Loading...