2007 harley softail turn signals left side stoped working right side works fine if i hold in the right blinker switch the hazards come on my alarm when armed all turn signals blink but when i press left turn signal nothing happens, any ideas

Replace the hazard switch. This will solve your problem.

hi

there is usually a turn signal relay under the dash that clicks when you turn left and right you may need to replace it they wear out over time
cheers

Sounds more like the flasher to me,in the drivers side fuse panel
square box ,looks like a relay , 5 male spade connectors on back.

left side front and rear lights and the turn signal is not working right side is right where problem.imam Harle Davidson Softail Deluxe in 2006 it was god.na cm 89921-01 A

,I suspect you have a bad flasher, it is usually located in the fuse box or near it. If this was helpful please leave me good feed back

OK so here is your solution. from your dealer when you purchased your bike with the alarm system you were given a 5 digit pin number. in order to turn it off manually you need to unlock (if locked) the switch, turn it to accessory.
push both left and right blinker buttons in
with the left blinker button is you "digits" so if (ex 56726) push the left button five times
to go to the next button push the right blinker one time then left six times
the right blinker one time and left blinker seven times
then right two times right once
left six times and right once. this will turn off the alarm

to program the fob you need to turn the ignition switch in a sequence of
on off on off on
with the blinker buttons you push
left left right left and your signals will flash the hazards twice
push and hold the fob button till the hazards blink three times and you have just programed your fob
push and hold your fob to set alarm and double click to disarm your alarm

When one side blinds faster than the other, the side than blinks faster means a light bulb burnt or not making contact. Are u sure the hazard light are the same with the blinkers

first just because a bulb looks good doesnt mean it is couple of peices of wire and a battery is all you need to test the bulbs secound thing the turn signal cancel works on the amount of flashes regardless of which side is on note:any bulb thats bad none on that side will work

I would check at the handlebar switch and go from there.I could be the short is in the switch.