Fuel tank cleaned, new filters, good fuel flow from pump, carbs?
SOURCE: will only run with full choke and absolutely no throttle.
Carbs gummed up. Need a serious cleaning or a full ruubers replacement/rebuild kit. Gas turns to gummy when left stting in the fuel bowls.
Use a couple of cans of Sea Foam.. best stuff in the world.
SOURCE: honda pal 2 stroke scooter
Are you adding oil to the gas? (32/1 = 4 ounces per gallon)
Do you still have spark? Install a new stock spark plug.
Clean the carb, but follow these steps >
Remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the two screws on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. Let the bike warm up then set the idle speed. This process should get you back on the road.
SOURCE: cbr 600 f3 will not start
wow, 7 years without use! try to check if the fuel pump motor is still working... also check the fuel lines if its clogged.. I hope you get your bike up and running again... feel that adrenaline rush when going 100+mph.. hehehe.. have a good one bro...
SOURCE: I have a 1996 Honda CBR 600F3. Bike ran fine for
if all cylinders die at the same time should be fuel or electrical?
935 views
Usually answered in minutes!
×