Hi there.im guessing your still battling with a rear brake caliper..1st un bolt and take the capliper off the disc ..2nd.fill the resevior up with fluid.leave the cap off the filler pot..3rd pump the rear brake pedal a couple times till u see the pistons in the caliper move..place a bit of wood in between the brake pads to stop the pistons popping out..pump the lever again a few times..if the caliper is to tight to put back on the disc..(not recommended) but prize the pistons appart with a spanner or flat screw driver..place the caliper bk on.top up fluid .put the filler cap bk on...to proper bleed it.take a 8 or 10 mill spanner.place on the caliper bleed nipple..place a rubber tube to the nipple.and drop the end into a jam jar with a little bit of fluid in .dip the end of the rubber tube into the fluid. .push down on the brake lever.and hold it down..whilst holding down the lever.undo the bleed nipple.u should see air bubbles come out in the jar of fluid..tighten the nipple back up.and release the lever..repeat the process till all theair bubbles have gone..fill up the filler pot.
138 views
Usually answered in minutes!
×