SOURCE: Need cylinder and cylinder head torque specifications 98 XR 250
you dont need torque specs on that just use a 1/2 inch drive with you 14mm or16mm socket hold the wratchet right at the top and tighten it as tight as you could get it like that then use wratchet in normal position and just give it a little snugg it will be perfect i have done it a million time on the same type of bikes...
SOURCE: 91 kx 250 torque values
Engine Top End:
Auto Decompressor Bolt 104 in·lb
Cylinder Head Cover Bolts 87 in·lb
Cylinder Head Bolts: M10 36 S
M6 104 in·lb S
the S in that means the specified pattern ... just like tightening car tire bolts... please note all that it its INCH lbs....
don't know why it says just 36 for the M10 bolts unless they left out inch lbs
Anything else let me know as i've got a manual for the 250 f... actually i've got a few different ones
Robert
Please take a moment to rate this solution as i've taken a few minutes to find the manual thanks
SOURCE: head bolt torque
Hi bengriffith1
You can download a copy of the engine manual from here
It has all the info you need. Any problems with the download just let me know
regards
robotek
SOURCE: need torque specs for 98 yz 250,rebuilding engine
Go to the site below and you can download a free srevice manual for your bike.
http://www.carlsalter.com/motorcycle-manuals.asp
Top rating due on this answer!
SOURCE: what is the head bolt torque spec for a kawasaki
28 nm buddy make sure you tighten them down evenly like opposite to opposite
435 views
Usually answered in minutes!
×