2002 Honda CR 125 R Logo

Related Topics:

A
Anonymous Posted on Mar 29, 2012

Kick start on Honda CR 125 seems to be stuck - 2002 Honda CR 125 R

3 Related Answers

Anonymous

  • 1 Answer
  • Posted on Apr 19, 2009

SOURCE: When I try to start my honda CR 250 the kick start

I had the same problem, and i was that the shaft that the kick start was attached to had sezied on to the idler gear in side the engine. all i did was drain the oil, remove the cover and replace the shaft and idler gear.

Ad

tombones

  • 3567 Answers
  • Posted on Apr 07, 2009

SOURCE: CR 80 R

Google " motorcycle service manuals "
or go to www.repairmanuals.com
or try your local library. Often guys will donate manuals to the library.

You might find a free pdf service manual on this site, they have a ton of them.
http://www.carlsalter.com/motorcycle-manuals.asp

Please rate this solution. Thanks!

Anonymous

  • 53 Answers
  • Posted on Mar 16, 2012

SOURCE: why is there gear oil in the crank case of my 2001 honda cr 80

Some one tried to get rid of the whinning noise it should have a lite wait oil in itJohnny

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a cr 125. I want to know if need to change the ring on my piston after driving it one summer?

Depends entirely on how much you drove it and how hard. Does it still start easily? Does it still seem to go like it always has? If it still seems healthy, it probably is. Bear in mind that bikes seem to slow down as you get used to them (or get fatter LOL).
0helpful
1answer

My 2002 Honda Cr 125 will not start. After about 20 kicks it makes this popping noise from the exahaust. It has good gas and the carb has been cleaned.

pull the spark plug check if it is wet/fouled,clean and dry it,then ground the pug to the head spin the motor and che the spark to see if you have spar arching across to the electrode tip if it is not and you hear but do not see it and it is sparking within the body of the plug replace it.
0helpful
1answer

2005 cr 125 wont start

The stator is the most common problem in that unit.
0helpful
1answer
0helpful
1answer

What should the compression range be on a 2004 cr

compression range is 120-160 ok but anything under 120 needs top end,if not you will start to where on those cylinder walls with the ring
0helpful
1answer

I put a new piston and gasket kit on my cr 125 1997 and it still has no compression at all you can push down the kick lever with your hand??i need help i just bought it two weeks ago

Honda 4 stroke, correct? It sounds like you have the valve timing off. Put a compression gauge on it and if you have 0 compression ,you shou;d reck your valve timing. Good Luck
0helpful
1answer

I have a 94 cr 125 , that i just bought , it started at the guys house but now wont start for me , tried putting a new plug in , any ideas

Try a compression test first see what it is, next check for spark, remove plug from engine leave connected, ground the end of the plug to the engine and kick over, if you have good compression and spark, it is in the carburation, some bikes dont start well when cold due to bad carburation(air leaks, bad jets etc)you could try roll starting down hill and see if it starts.
0helpful
1answer

Honda cr 125 new top end rebuild started ok but when switched of petrol leaks out of overflow tube every couple of minuates

sounds like the float in the carb is stuck or set to the wrong hight give the carb a few taps with a screwdriver if that dont work take the carb off and check the float and needle.
Not finding what you are looking for?

474 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...