Front fork oil level for 06 wr250f

The amount of oil that goes in the forks of a 1982 Suzuki GS 750T will depend on the type of forks that are installed on the motorcycle. It is important to use the correct amount of oil to ensure that the forks are functioning properly.
If your Suzuki GS 750T has standard telescopic forks, you will need to add 10.8 ounces (320 mL) of fork oil to each fork. If your motorcycle has air-assisted forks, you will need to consult the owner's manual to determine the correct amount of oil to use.
To add oil to the forks, you will need to remove the fork caps and use a fork oil level gauge or a piece of wire to measure the amount of oil in the forks. If the oil level is too low, add oil until the forks are filled to the correct level. If the oil level is too high, remove excess oil until the forks are at the correct level.
I hope this information helps! Let me know if you have any other questions.

Spare parts and accessories for YAMAHA FZ8 RN25 - Louis

https://www.louis.eu > rund-ums-bike > bike-datenbank

Fork oil per rod: R:555 ML/L:563 10W ; Engine oil w/o filter: 2,9 L SAE 10W-40 ; Engine oil with filter: 3,1 L MIN. API SG ; Brake fluid: DOT 4 ; Fuel: 17,0 LITER.

SOLVED: Yamaha fz front fork oil capacity - Fixya

https://www.fixya.com > Forum > Motorcycles > Yamaha
Sept 4, 2019 - Use Yamaha suspension oil #01. Amount is 19 ounces. Oil level from top surface w/o cap nut is 3.15" to 5.51". I am sending you a link to a site where you can ...
Fork oil fz8 abs how much fluid is used
Apr 30, 2014
SOLVED: How much fork oil in yamaha fz 16
Apr 3, 2015
How to change front fork springs on a Yamaha fz8
Nov 19, 2019
Whats the correct amount of fork oil per leg in cc
Nov 24, 2019
More results from www.fixya.com

600cc 05/06
Front Fork Oil cc (right leg):467Front Fork Oil cc (left leg):467

Standard oil level:
90 mm (3.54 in)
Extent of adjustment:
80 ~ 120 mm (3.15 ~ 4.72 in)
From top of outer tube with
inner tube and damper rod fully
compressed without spring.

CAUTION:
Adjust the oil level in 5 mm (0.2 in) incre-
ments or decrements. Too low oil level
causes the front fork to produce a noise at
full rebound or the rider to feel some pres-
sure on his hands or body. Alternatively,
too high oil level will develop unexpectedly
early oil lock with the consequent shorter
front fork travel and deteriorated perfor-
mance an characteristics. Therefore, adjust
the front fork within the specified range.

FORK OIL
• Place the front fork vertically without spring.
• Compress it fully.
• Pour specified front fork oil up to the top level of the outer
tube.
 Capacity (each leg): 490 ml (16.6/17.3 US/lmp oz)
 99000-99044-L01: SUZUKI FORK OIL L01
or an equivalent fork oil
• Move the inner rod slowly with the special tool ten times and
more until no more bubbles come out from the oil.
 09940-52841: Inner rod holder
NOTE:
Refill front fork oil up to the top of the outer tube so that bubbles
are visible while bleeding air.
• Refill specified front fork oil up to the top level of the outer
tube again. Move the outer tube up and down several strokes
until no more bubbles come out from the oil.
• Keep the front fork vertically and wait 5 – 6 minutes.
NOTE:
* Always keep oil level over the cartridge top end, or air may
enter the cartridge during this procedure.
* Take extreme care so as to pump out air completely.
• Hold the front fork vertically and adjust fork oil level with the
special tool.
NOTE:
When adjusting the fork oil level, compress the outer tube fully
without the fork spring.
 Fork oil level: 153 mm (6.02 in)
 09943-74111: Front fork oil level gauge

Please check the owner's manual.

Recommended fork fluid: Pro-Honda Suspension Fluid SS-8 Fork fluid capacity/level: 474 ± 2.5 cm3 (16.0 ± 0.08 US oz)/100 mm (3.9 in)