20 Most Recent
2002 Yamaha XT 600 E Questions & Answers
My yamaha xt600e starts to to choke/stall like if
You may very likely have an issue with your carbies. The jets may be gumming up with sediment over time or secondary carby needle is worn or sticking. A carby cleaning execise may be a cure or a service at your bike dealer if your not mechanically minded. The carbies are a little more complicated than the normal single carby and have more jets and slides, as well as a delayed secondary carby linkage.
Try the site below for a free download of your bikes manual which will have some troubleshooting tips and some service for the carby's.
Cheers!
http://www.yamahaownershandbook.com.au/index.php?BRSR=20
I looking for yamaha moto parts
you may want to google it
http://www.google.com.ph/#hl=tl&ei=v1JHS6b1N86GkAWrx8H5Ag&sa=X&oi=spell&resnum=0&ct=result&cd=1&ved=0CBIQBSgA&q=yamaha+motorcycle+parts&spell=1&fp=ef92f4d303797f9c
When in first gear with the cluch in it keeps
Sounds like you need to adjust your clutch. Over time the friction plate material wears down and takes up the slack in the clutch pivot throw. I normally suggest buying a proper manual for anything vehicle related. It could be simply adjusting the slack in the cable. But it sounds like a wearing down clutch plate issue.
No spark
remove the ignition coil from the bike.
The primary winding should have a resistance between 2 and 6 ohms
The secondary winding should have a resistance between 19Kohm and 40Kohm.
In fact the primary must have less than a 50ohm, but there MUST be a resistance.
The secondary should have a resistance of 15.000Ohms and more, but there MUST be a continuity.
Grips replacement
u can take the current ones off by simply heating them to warm the cement then pull...if that doesnt work u could use a razor blade but bake sure that u dont cut anything.
you could put the wire around the grip if u want its all up to u.
Not finding what you are looking for?