20 Most Recent 2000 Harley Davidson FLHR-FLHRI Road king Questions & Answers

Actually, the disconnect has TWO o-rings = one to seal it to the tank: http://i74.photobucket.com/albums/i274/uplandhunter/DSCN0057.jpg Needed only if there's a leak between the disconnect and the tank. And one INSIDE the disconnect: http://i74.photobucket.com/albums/i274/uplandhunter/DSCN0058.jpg Kinda hard to see in this photo, but look close down inside. Also, when reconnecting fuel line, put a dab/drop of oil on the male fitting (too hard to do the female fitting, oil doesn't like to run UP-hill). This will make the fitting go together easier and lube the o-ring to help prevent cutting it. Also, it helps to oil the o-ring to help install it into the disconnect and the oil left on it will help as mentioned above.

There is a bendix gear in the starter which is pushed out to the flywheel when the starter button is pushed. If you hear the starter spinning but the starter is not turning the engine over, the bendix gear is stuck. Rebuild the starter. If you do not hear the starter spinning, you have a wiring problem.

(1) harley vibrates make sure kickstand stays up. (2) you have to find it. there is a tilt switch on bike. if it lean over to far it will kill the bike. check to see if its ok.

I doubt seriously that you are going to find an online service manual for your bike. The reason is that Harley-Davidson is very protective of their copyrighted material. I'm not saying that you can't find out how to fix a particular problem online but a downloadable service manual is something that I've never seen unless it was for some very old or no longer made Harley, like maybe the Italian Harleys. Go to this site to find your service manual but you'll have to buy it if you want it.
http://www.diyrepairmanuals.com/makes.asp I'm sorry I can't help anymore than that because if I could find the manuals online, I'd download every one of them. Sure would help in what I'm doing here and out in the shop.

Good Luck
Steve

Most of the electronic speed sensors are located on the right rear corner of the transmission. I think this is what you're asking anyway.

Good Luck
Steve

WHEN A BULB IS BAD, THE FLASHERS BLINK VERY QUICKLY. YOUR TURN SIGNAL SWITCH MAY BE WORN OUT.

THE GAUGE MAY BE BAD.

Harley Davidson Wiring Diagrams and Schematics ,,,,..

Hi! For more information about your issue, please visit the websites below, and for specific information or questions, please feel free to contact me at [email protected] . http://www.motorpartstore.com.Good luck and have a nice day.