I have bajaj pulsar 150cc 2005 make, when the vehicle is in cold or when we start the bike in the morning or start the bike after parking it for more than 2 hours. The vehicle idelling or RPM will go down and it off the vehicle if i dont raise the exsalator after running for more than 10 mins the vehicle RPM will be in 1500 RPM. Only when the vehicle is in cold condition the RPM goes to zero if i dont raise the exsalator. If we increase the idilling to 1500 RPM in cold condition of the vehicle after running the bike for 10 mins it will increase to 2500 RPM. i have taken to service station but it was difficult to reproduce the issue. can you please suggest.
This problem might b due to some block in your bik's carburetor better suggest ur mechanic to clean it up thoroughly and this may fix ur prob. Even then if ur having the same problem then change to a new carburetor...try 2 fix this problem as soon as possible else you ll get very low milage......
Posted on Dec 08, 2008
my pulsar headlight dome was broken so i want to know the cost of new head light dome for pulsar 150cc
It costs around 800.... but with fitting charges costs u around 900....
better go for a non branded which will be similar to the original costs around 400 or so... because u may not be knowing when it may gets scratches or breaks... Just think.....
Srinivas..................
Posted on Aug 03, 2009
PLEASE GIVE ME THE WIRING DIAGRAM OF BAJAJ PULZAR 150
place give me a wiring diagram of bajaj pulsar 150
Posted on Mar 27, 2013
oil changing in bajaj pulsar 2004 model
start the engine and run for about 5 mins to heat the oil up, this helps the oil to come out of the engine.
turn engine off
undo oil drain bolt (remeber to have a basin underneath to catch old oil)
undo oil filler cap (more oil will come out)
pour some fresh oil in to clear out remaining old oil
clean and replace oil drain bolt and washer
top up with correct amount of 20W40 (recommended JASO-MA 20W40)
list of instructions can be found here http://bajajpulsar.org/?page_id=9
Posted on Jan 25, 2010
I own a bajaj pulsar 180 dtsi - UG3...... I like K & N products......So can anyone suggest me how to change my bike's stock oil filter to K & N oil filter..............
how much engine oil is requird for the pulsar 180
Posted on Mar 26, 2010
I have bajaj pulsar 150CC Dec 2008 Model. Since last few months (3-4) months I am facing problem with my bike. Whenever I speed up beyond 60-65, bike starts to wobble a littel. I feel like I might loose balance if I stretch beyond 70KMPH. I got my bike checked from the mechanic from whom I had got all the servicings done so far. He said there is no problem, but I could feel it. Can anyone tell what could be the problem and how to fix it.
I have bajaj pulsar 150CC 2003 Model. Since last few months (3-4) months I am facing problem with my bike. Whenever I speed up around 40-60, bike starts to wobble. I feel like I might loose balance, after the speedometer reaches 65 KMPH it moves with no wobbling. I got my bike checked from the mechanic from whom I had got all the servicing done so far. He said there is no problem, but I could feel it. Can anyone tell what could be the problem and how to fix it.
Posted on Jun 24, 2010
I have a Bajaj Pulsar 150cc DTSi (2005). It's giving a decent mileage of 55kmph. But, it has a couple of problems: 1. The pickup is terrible. The bike has very less pickup even in the lower gears. 2. It goes smooth until 50-55kmph. When I try to go over 55kmph speed, it makes lot of noise. and the RPM meter seems to stay at around 4000 mark. Can anyone suggest how to get the above problems fixed/
plae check ur cluth plates and more chain set
Posted on May 20, 2010
does cdi affect ignition in pulsar 150
yes the cdi is most importing.the starter coil supply electricity to cdi then cdi forward electricity to high tension coil,and high tension coil forward the electricity to spark plug,spark plug give more fire to piston.cdi not only supply only electricity,cdi adjust the electricity and control the power.ok?
Posted on Jul 18, 2012
is air screw for mikuni ucal carburettor bs26 available in the market as spares?
yes it is,contact the original bajaj spare dealers.
Posted on Jul 18, 2012
How much pressure of gas to be fill into shock absorber?........ and normal AIR can fill into shock absorber...!
The new Pulsar 150 has RSA with Coil Springs and Suspension Fluid. If the Springs are fine, then get the shocks filled with equal amounts of Fluid at major Service Centers (Few workshops have it).
Else, if the Springs are weak, they can be adjusted by Local Shock Absorber Repairers (Dealers do not suggest it and do not have any mecanism to do it).
If neither of the above works, you have to finally change to a new Set of Rear Shock Absorbers...
Posted on Dec 28, 2013
218 questions posted
Usually answered in minutes!
260 Questions
41 Questions
98 Questions