SOURCE: Kia Door Handle
Remove the door trim inside by loosen 3 bolt with screw driver, then pull out the door trim, after that loosen the hex.bolt (3 hex-bolt) on lock mechanism bracket, after that you can loose bolt (4 hex bolt) on handle cover. Be careful to not drop the bolt, because the gap on sliding door is too narrow. After you removing the handle assembly you can see where is the broken. You can remove the handle from cover by removing pin clips on it. To fixing the broken handle you can just using plastic glue or you can drill a small hole and put some small wire to reinforce the plastic.
SOURCE: how do you change the right front headlight bulb on a kia sedona
Remove the headlight assembly. Just remove the 3 bolts with a 10 mm socket and pull it out so you can disconect the wire harness. After that pull the whole assembly out and unscrew the bulb cover. The bulb is held in with a spring clip.
SOURCE: NEED TO CHANGE THERMOSTAT ON 03 KIA SEDONA. INSTRUCTIONS?
Here is a link:
http://wiki.answers.com/Q/Where_is_the_thermostat_and_how_do_you_change_it_on_a_2003_Kia_Sedona
SOURCE: 2003 Kia Sedona Ex. Squeaks when brakes
Most likely, there are metal peaces on the break pad, for when the pads get wore down to a certain point they rub the rotor to let you know its time for new breaks.
SOURCE: 2003 Kia Sedona Engine light is on
Your engine light come's on when your pcm (powertrain control module) senses a problem with the input of one or more of the many sensors on your vehicle, you can retrieve the engine light trouble code with a OBD II diagnostic tool, you can buy one at most auto parts store's, if you don't want to spend the money to buy one some auto part's store's will retrieve the engine trouble code's at no cost, for example auto zone, after retrieving the trouble code it should point you in the right direction for fixing the problem.
good luck,
hope this was helpful.
429 views
Usually answered in minutes!
×