How do you take off the passenger door for a 2003 Chevy Avalanche?
Just replaced 2004 passenger side motor. Bought motor/gearbox for 31 dollars, free shiping on line, removed motor and regulator , looks like a guide with cables, leaving it all together. We taped window at top and used a pair of small vice grips to clamp the small cable to the frame so it wouldn't move . As we removed the 3 small screws holding the motor/gearbox in place , it slips out showing it has a large plastic spline gear slightly visible . We used a small screw driver to seperate the gear/motor from what looks like a barrell with that cable wrapped around it. We were careful
not to let this cable drum get loose, so we made sure one person held it inside the housing. Slipped the new drive in and done with that. No one mentioned there was a bracket holding the door panel and I had to pop out the manual lock button to access a small screw, don't drop that screw down insde the door, would be hard to get out. I didn't have to make any adjustment and it works great.
Hello, I have a 2004 Avl. I replaced the driver door window mechanism myself. You need to pry out the electric window controls with a dull blade as to not tear the vinyl. Disconnect the controls carefully. There are small release clips that hold the switch buttons onto the electric base. Then the arm rest, there is a long screw under the armrest. At the front towards the mirror there is a long screw under a round plastic snap cover. I believe it is a small metric bolt. Next grasp the bottom end of the door cover and pull with a sharp snap. Continue around the door panel gently pulling the snaps loose from their base. The door panel cover does not cantain screws only snaps. There is a clear plastic water barrior you need to be careful to peel without tearing and place on a clean flat surface with sticky side up. I had to replace the window track and motor all in one piece, can't just replace track. I purchaces the mechanism on-line parts store.
You don't take the door off, you take the door panel off.
There should be a screw or 2 around the pull handle on the inside, along with a screw or 2 around the door release handle, then grab a good sturdy putty knife and your fingers and start pulling the plastic panel away from the metal door.
Use common sense and be gentle yet firm.
Good Luck!!
P.S. You can be carefull once you take the panel off and peel back the plastic lining, but if you rip it don't worry about it... do the best you can
1,950 views
Usually answered in minutes!
How do you take of the door of a 2003 Chevy Avalanche Truck to replace the passenger window motor? Thanks.
how to take off interior door skin to repair window motor . Something has gone to ground no power in whole truck
×