Instument cluster dose'nt work - 2001 Jeep Wrangler

The cluster itself. If power and ground to cluster are good then it's likely that the cluster needs to be replaced.

re[place instument cluster its an intermitand problem the abs light is probaly because the cluster isnt talking on the buss then it crashes and no one is talking so all the lights come on

sounds like a fuse check all fuses check owners manual where fuse box is look for one labeled instument panel

there is a lot of issues with GM instument clusters .I have a 2004 chevy cavalier in my shop with the same problem. just replace the instument cluster

There is no fuse for just the odometer("mileage indicator")The entire instument cluster is on the same fuse.If the odometer isn't working,but the speedometer is,you will have to send the cluster for repair(this is a specialty repair shop,due to legal issues of possible odometer tampering)

The first thing to do is reach up (if possible) behind the cluster and make sure the plugs to it are fully inserted, push them in or remove and reinsert if possible to reach them. If that doesn't fix the problem the entire cluster must be removed and then sent out for repair to a shop that repair Chrysler electronics.

If the warning lights work we will assume the fuse for "cluster" or "gauges" is good, so the problem may be in the printed circuit board inside the cluster. I can't tell if there is more than one power wire for the cluster from the fuse box.

resisitors in cluster need replacing. look on you tube and radio shack has them for $1.96. takes 20 minutes to fix.

No,the speed sensor is for calcultions for the ABS brake system.The speedometer problem is an on going problem that GM has with there instument clusters.You'll have to replace the instument cluster to fix the speedometer problem.As for transmission problem i would chenge the fluid and filter if you are having shift problems,if problem still exists after servicing transmission have the shift solenoids checked sounds like they maybe sticking.

well the issue is youe enitre gauge cluster i do understand that your speedometer is working but it is a cable speedometer not electronic like everything else in the gauge cluster so first i would recomend checking the voltage getting to your gauge cluster then just replace the guagecluster they are really cheap i a salvage and not hard to install at all but the cluster itself is not very comon to go out so make sure you check voltage to it first i wouldnt want you to go through buying and replaceing the cluster and that not fix it